5.
Component Expansion/Function Enhancement
Installing Long Wave SFP+ Modules (16Gbit/s)
Long Wave SFP+ Modules (16Gbit/s) Installation Procedure
This section describes how to replace a Short wave SFP+ module (16Gbit/s) in the host interface (FC 16Gbit/s)
with a Long wave SFP+ module (16Gbit/s).
1
Check that all components of the ETERNUS AF are in normal status, using the [Storage System Status]
screen of ETERNUS Web GUI.
2
Check the port location of the Short wave SFP+ module (16Gbit/s) that is to be replaced by using the Inter-
nal Parts information in the [Channel Adapter Detail] screen.
Note that a Short wave SFP+ module (16Gbit/s) is displayed as "16G SFP+(MMF)" in the "SFP Type" field.
3
Turn off the ETERNUS AF.
Refer to
"Powering Off" (page 37)
4
Wear a wrist strap or touch a metal part to discharge the human body's natural static electricity.
5
Disconnect the FC cable that is connected to the FC port in the Short wave SFP+ module (16Gbit/s) that is to
be replaced.
Push the tab on the FC cable connector and pull out the cable.
Make sure to record the connecting port for the disconnected FC cable.
6
Remove the Short wave SFP+ module (16Gbit/s).
(1)
Open the Short wave SFP+ module (16Gbit/s) lever upward.
(2)
Pull the Short wave SFP+ module (16Gbit/s) straight out of the port cage.
Make sure to store the removed Short wave SFP+ module (16Gbit/s) with the fixing lever and the con-
nector cover attached.
If SFP+ modules are installed in a way other than as described here, damage and/or
•
device failure or electrical shock may occur.
for details on how to turn off the ETERNUS AF.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
65
P3AG-1842-06ENZ0