Table 3 Status And Meanings Of Each Led (Controller) - Fujitsu ETERNUS AF250 S2 Basic Operation Manual

1. Component Names and LED Names
Controller Enclosures
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 3 Status and Meanings of Each LED (Controller)

LED name
IDENTIFY/BBU FAULT
DI (OUT) LINK/FAULT
READY/FAULT
MASTER
CA FAULT
LINK/FAULT
LAN ACT
LAN LINK
LED status
(blinks blue)
(amber)
(green)
(amber)
(blinks amber)
(green)
(blinks green)
(amber)
(blinks amber)
(green)
(amber)
(green)
(amber)
(blinks green)
(green)
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
Meaning
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installation
location of the controller is identified.
The battery is in error status.
The link between the DI (OUT) port and the destination port has
been established.
The link between the DI (OUT) port and the destination port is in
error status.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
The controller is in normal status.
An error has occurred during startup.
The controller is performing the initial setup after the power is
•
turned on.
The controller is in error status.
•
The controller is set as a Master CM.
The host interface is in error status.
The link between the host interface port and the destination port
has been established.
The host interface port is in error status.
Data is being sent or received via the LAN port.
The link between the LAN port and the destination has been es-
tablished.
13
P3AG-1842-06ENZ0