Honda Dream DX CD110 Owner's Manual page 52

8. Right side of case - Total 5 claws
(Front-1, Mid-3, Rear-1)
9. Left side of case - Total 1 claws (Front-1)
10. Visually confirm that all claws are
installed correctly.
11. Fasten all 4 bolts.
12. Install the inspection cap.
Adjustment:
Drive chain slack should be checked and
adjusted (if necessary) at every 1000 km
(600 miles). When operated at sustained
high speeds or under conditions of frequent
rapid acceleration, the chain may require
more frequent adjustment.
If the drive chain requires adjustment, the
procedure is as follows:
1. Place the vehicle on its center stand
with the transmission in neutral and the
ignition switch OFF.
2. Loosen the "Rear Axle Nut' (1) and
"Sleeve Nut" (2).
3. Loosen the "Drive Chain Lock Nuts" (6).
4. Turn both "Drive Chain Adjusting Nuts"
(3) an equal number of turns until the
correct drive chain slack is obtained.
48
CD110 Dream DX
Turn the adjusting nuts clockwise
tighten the chain, or counterclockwise
to provide more slack.
Align the chain adjuster "Index Marks"
(4) with the rear edge (5) of the
adjusting slots on both sides of the
swingarm.
(6) (4)
(3)
(1)
(1) Rear Axle Nut
(2) Sleeve Nut
(3) Drive Chain Adjusting Nut
(4) Index Marks
(5) Rear Edge Of Adjusting Slot
(6) Drive Chain Lock Nuts
Honda Motorcycle & Scooter India Pvt. Ltd.
(5)
(5)
(4)
(2)
(3)
to
(6)