Table of Contents
Advertisement
Available languages
Available languages
T
roubleshooting
Vacuum cleaner won't run
Possible causes
1.
Vacuum cleaner is not plugged in
2.
Power button is not pressed down
Vacuum cleaner won't pick up or low suction
Possible causes
1.
Tools, flex hose and/or telescoping
extension wand are blocked
2.
Filters are dirty
3.
Dirt cup is full
4.
Dust bag is full
5.
Swivel hose not securely attached to suction opening
Vacuum cleaner won't pick up or low suction
Possible causes
6.
Crack or hole in flex hose
7.
Air flow regulator or variable suction power
control is set to open or minimum setting
Visible dust escaping from vacuum
Possible causes
1.
Dirt cup is full
2.
Dust bag is full
3.
Filters missing or installed incorrectly
4.
Filters are dirty
5.
Flex hose is blocked
6.
Swivel hose not securely attached to suction opening
7.
Crack or hole in flex hose
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
w w w . b i s s e l l . c o m
WARNINg:
To reduce the risk of electric shock,
turn power OFF and disconnect plug
from electrical outlet before performing
maintenance or troubleshooting.
Remedies
1. Check electrical plug
2. Press power button down
Remedies
1. Remove each part and check for blockages
2. Check and clean or replace all filters
3. Empty dirt cup
4. Replace with new dust bag
5. Make sure swivel hose is locked into
suction opening
Remedies
6. Check hose and replace if needed
7. Change to closed or maximum setting
Remedies
1. Empty dirt cup
2. Replace with new dust bag
3. Check all filters for correct installation
4. Check and clean or replace all filters
5. Remove hose and check for
blockages
6. Make sure swivel hose is locked into
suction opening
7. Check hose and replace if needed
13
Advertisement
Table of Contents
