Bissell OptiClean 60A4 Series User Manual page 28

m
aintenance and care
Replacing HEPA media filter*continued
3. The dirt cup foam filter is located
between the bottom of the dirt cup and
the HEPA media filter*. Once the HEPA
media filter* has been removed, the
foam filter can then be removed and
cleaned or replaced as needed. To
clean the foam filter, wash with warm
water and a mild detergent. Be sure
to air dry completely before replacing
this filter back in the dirt cup.
4. To re-install the filters in the dirt cup,
turn dirt cup upside down and replace
the foam filter. Then replace the HEPA
media filter* by inserting the tabs on
the back of the filter into the slots on
the bottom of the dirt cup and snap the
filter back into place.
Clearing clogs from the dirt cup
1. To clear clogs from the dirt cup,
remove the top cover and set aside.
2. Empty the dirt into a garbage container.
3. Reach down into the dirt cup cyclone
chamber to clear any dirt or debris
from the cyclone and empty into a
garbage container.
4. Remove the dirt cup HEPA media filter*
and foam filters and set aside.
5. Remove any dirt or debris from the
cyclone chamber opening.
6. If the holes in the cyclone appear to be
clogged, place the cyclone chamber
opening underneath running water and
allow water to run through the holes in
the cyclone to clear any clogs. Be sure
to allow the entire dirt cup assembly
to dry completely before replacing
the dirt cup HEPA Media Filter* and
foam filter.
*
The filter media, not the vacuum as a whole, complies with IEST-RP-CC001.5 HEPA standard.
12
w w w . b i s s e l l . c o m
3.
4.
3.
5.
Cyclone
Chamber
Opening