Preparing The Remote Control - JVC UX-G950V Instructions Manual

⁄
To connect the powered subwoofer
From the powered subwoofer
(not supplied)
The connected subwoofer can reproduce the bass sounds
recorded in front left and right channels, but cannot
reproduce the LFE signals encoded in multi-channel
software.
• Before plugging the System to the power supply, make
sure that the powered subwoofer is turned off.
@
TV/monitor
Connect either component cord or SCART cord.
Red
Blue
• This connection allows you to use the progressive
scanning mode. To select progressive (PROGRE)
scanning mode (see page 16), use VIDEO OUT
(COMPONENT) jacks.
SCART cord
(not supplied)
• After connecting a TV, select the appropriate video
signal output according to the connection method. See
"Changing the Scanning Mode" on page 16.
When connecting a USB mass storage class device
On the front panel
Green
Component video
cord (not supplied)
• This connection sends the
video signal (Composite, Y/C,
or RGB) and receives audio
signal from TV. To listen to
the TV sound, see page 10.
USB cable (not supplied)
• When connecting with a USB cable, use the USB 2.0 cable
whose length is less than 1 m.
• You can connect a USB mass storage class device such as
a USB flash memory device, hard disk drive, multimedia
card reader, etc. to this System.
• You cannot connect a computer to the USB MEMORY
REC/PLAY ( ) terminal of the System.
• You cannot connect JVC Everio camcorder to the USB
MEMORY REC/PLAY (
• Noise and static electricity may stop the USB mass
storage class device sound. In this case, disconnect and
connect the USB mass storage class device again after
turning off the System.
When connecting a digital audio player
On the front panel
Stereo mini plug (not supplied)

Preparing the remote control

Insert the battery into the remote control by matching the
polarity (+ and –) correctly.
If the range or effectiveness of the remote control decreases,
replace both batteries.
Caution
Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
When using the remote control
Point the top of the remote control towards the remote
sensor as directly as possible. If you operate it from a
diagonal position, the operating range (approx. 5 m) may
be shorter.
) terminal of the System.
From audio output (or
headphone out, etc.)
6