Preparing The Remote Control - JVC NX-T5 Instructions Manual

• Do not place anything on top of the main unit. Doing so
may cause the main unit to fall down, and cause injury to
the persons around.
• Do not climb onto the main unit or hang from it. Doing
so may damage the main unit and/or cause injury to the
person.
Take care specially when there are small children at the
home.
• Avoid sandwiching the cords between the main unit and
wall. This may upset the balance of the main unit and
cause the main unit to fall down.
• Make sure that the connected cords will not interfere
with daily activities and that the users will not be caught
in the cords.
• Do not pull the connected cords with excessive force.
• Check regularly that none of the screws are loose.
• In the event that the main unit has fallen, turn off the
power, disconnect the power cord from the AC outlet.
Then, contact your dealer for an inspection and repairs.
Using the main unit in this state may cause a fire or
electrical shock.
• Do not place valuables (breakables) underneath the
location where the main unit is installed. They will be
damaged if the main unit should fall.
JVC bears no responsibility for any accidents or damage
resulting from inadequate assembly or mounting,
insufficient strength of attachment, misuse or abuse, or
natural disasters.

Preparing the Remote Control

Insert the battery into the remote control by matching the
polarity (+ and –) correctly.
R03/LR03/AAA
• If the range or effectiveness of the remote control
decreases, replace both batteries.
When using the remote control
Point the top of the remote control towards the remote
sensor as directly as possible. If you operate it from a
diagonal position, the operating range (approx. 5 m) may
be shorter.
When placing the main unit vertically (with the DISPLAY MODE
switch set to "V")
Remote sensor
When placing the main unit horizontally (with the DISPLAY
MODE switch set to "H")
Remote sensor
12