JVC UX-G950V Instructions Manual page 8

~
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
AM loop antenna (supplied)
Turn it until the best reception is obtained.
If the cords are covered with vinyl,
remove the vinyl to expose the tip of the
cord by twisting the vinyl.
FM antenna (supplied)
Extend it so that you can obtain the
best reception.
For better FM reception
Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75 Ω wire with coaxial type
connector (IEC or DIN45325).
5
Ÿ
• When connecting the speaker cords, match the polarity
From right speaker
!
FM outdoor antenna
(not supplied)
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO"
• The digital signal through the OPTICAL DIGITAL OUT
Speakers
of the speaker terminals: red to (+) and black to (–)
Insert
Red
Black
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom of
the speakers.
Digital audio component
Protective cap
menu correctly according to the connected digital audio
equipment (see page 39).
terminal is transmitted only when "DVD/CD" is selected
as the source.
Press and hold
Release
Red
Black
From left speaker
Optical digital cord
(not supplied)