Ricoh AP2600 Operating Instructions Manual page 89

Possible Cause
Is the Data In indicator
blinking or lit after starting
the print job?
Do you print via a net-
work?
If not blinking or lit, the data is not being sent to the printer.
If the printer is connected to the computer using the in-
terface cable
Make sure the printer port settings are correct. For a parallel
port connection, port LPT1 or LPT2 should be set.
• Windows 95/98/Me
A
Click [Start], point to [Settings] and then click [Printers].
B
Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].
C
Click the [Details] tab.
D
Check the [Print to the following port] box to confirm that
the correct port is selected.
• Windows 2000
A
Click [Start], point to [Settings] and then click [Printers].
B
Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].
C
Click the [Port] tab.
D
Check the [Print to the following port] box to confirm that
the correct port is selected.
• Windows NT 4.0
A
Click [Start], point to [Settings] and then click [Printers].
B
Click to select the icon of the printer. Next, on the [File]
menu, click [Properties].
C
Click the [Port] tab.
D
Check the [Print to the following port] box to confirm that
the correct port is selected.
Network Connection
Contact your network administrator.
Confirm that the "Ethernet" setting is correct from the operation
panel. See P.120 "Host Interface Menu".
The setting governs the data transfer speed used by the Network
Interface Board. Three options are available:
• Auto (default)
• 100 Mbps
• 10 Mbps
Note
For details about the appropriate setting to use on your net-
work, contact your network administrator.
Printer Does Not Print
Solutions
5
77