Ricoh AP2600 Operating Instructions Manual page 82

Troubleshooting
Messages
Full: Waste Toner
Hex Dump Mode
Low: Toner
Malfunction: Upper Tray
Mismatch: Paper Size
5
Mismatch: Paper Size and
Type
Mismatch: Paper Type
No Paper: Bypass Tray
No Paper: Input Tray(s)
No Paper: Selected Tray
No Paper: Tray 1
No Paper: Tray 2
70
Description
The toner is almost run out.
The printer is in Hex Dump
Mode.
The toner cartridge is not set
correctly or toner is almost
running out.
An error has occurred in the
upper tray.
The paper size setting of the
tray differs from that of actual
paper size in the tray.
The paper type setting of the
tray differs from that of actual
paper type in the tray.
The paper type setting of the
tray differs from that of actual
paper type in the tray.
There is no paper of the indi-
cated paper size in the bypass
tray.
There is no paper of the indi-
cated paper size in the paper
tray.
There is no paper of the indi-
cated paper size in the current
tray.
There is no paper of the indi-
cated paper size in the paper
tray (Tray1).
There is no paper of the indi-
cated paper size in the option-
al Paper Feed Unit (Tray2).
Comments
Prepare a new toner cartridge.
Wait for a while. If the "Hex
Dump Mode" message does
not change, on the panel dis-
play press {Online} to return
to the "Ready" condition.
Set the toner cartridge correct-
ly.
First, turn the power switch
off and then on. If the message
appears again, call your sakes
or service representative.
Load paper of the indicated
paper size into the paper tray
being used. See P.25 "Paper
and Other Media Supported by
This Printer".
Load paper of the indicated
paper size and type into the
paper tray being used. See
P.25 "Paper and Other Media
Supported by This Printer".
Load paper of the indicated
paper type into the paper tray
being used. See P.25 "Paper
and Other Media Supported by
This Printer".
Load paper into the bypass
tray. See P.41 "Loading Paper in
the Bypass Tray".
Load paper into the paper
tray. See P.38 "Loading Paper in
the Paper Tray".
Load paper into the current
tray. See P.38 "Loading Paper
and Other Media".
Load paper into the bypass
tray. See P.41 "Loading Paper in
the Bypass Tray".
Load paper into the bypass
tray. See P.41 "Loading Paper in
the Bypass Tray".