Search - Toshiba D-VR17KB Owner's Manual

E9GA0BD_EN.book Page 73 Monday, March 26, 2007 10:14 AM
Accidental erasure prevention
To prevent accidental recording on a recorded
cassette, remove its record tab. To record on it later,
cover the hole with cellophane tape.
Record tab
One-touch Timer Recording
VCR VCR
This feature allows you to set the recording length
simply by pressing [REC I].
1
Turn on the unit and insert a
recordable tape.
Make sure that the TV input is set on the unit.
2
Press [VCR].
3
Select the recording mode using
[REC MODE]. (See page 72.)
4
Select the desired channel to record
using [PROG.
[the Number buttons].
5
Press [REC I] repeatedly until the
desired recording time (30 minutes
to 8 hours) appears on the TV
screen.
One-touch Timer Recording will start.
Normal Recording
8:00
• When the unit reaches the specified time, it will be
turned off automatically.
• To change the recording length during One-touch
Timer Recording, press [REC I] repeatedly until the
desired length appears.
• To cancel One-touch Timer Recording within the
specified time, press [STOP S].
Hint
• The remaining recording time will appear on the TV
screen during One-touch Timer Recording. Press
[DISPLAY] to see it on the TV screen.
Note
• If VCR One-touch Timer Recording is completed
during DVD playback or recording, the VCR will be
in stop mode and the DVD keeps the current mode.
• You cannot use the pause function during One-
touch Timer Recording.
• When One-touch Timer Recording is finished and
the power is turned off, the unit will switch to the
timer-standby mode automatically if a timer
recording has been programmed. Press
[TIMER SET] to cancel the timer-standby mode in
order to use the unit continuously.
/ ] or
0:30
1:00
7:30

Search

Index Search
VCR VCR
1
Press [VCR].
2
Press [SEARCH] so that the index
search menu appears.
3
Enter the number of recordings you
wish to skip using
[the Number buttons] within 30
seconds.
4
Press [FWD f] or [REV r] to start
index search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After index search, the VCR will play back the
tape automatically.
Note
• This function is not available during recording.
• Every time a tape is recorded, an index mark is
written on the tape.
• You can make the index mark up to 20.
Time Search
VCR VCR
This feature allows you to go to a specific point on a
tape by entering the exact amount of time you wish to
skip in order to reach the point.
1
Press [VCR].
2
Press [SEARCH] repeatedly until the
time search menu appears.
3
Enter your desired time to skip using
[the Number buttons] within 30
seconds.
4
Press [FWD f] or [REV r] to start
time search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After time search, the unit will play back the tape
automatically.
Note
• This function is not available during recording.
• Press [STOP S] to stop the search.
• If the tape reaches the end during the search, this
unit will cancel it and rewind the tape.
• You can set the time up to 9:59.
73
EN