Divx - Toshiba D-VR17KB Owner's Manual

E9GA0BD_EN.book Page 70 Monday, March 26, 2007 10:14 AM
1
Select the desired setting using
[U / D], then press [ENTER].
Video Out
SCART (RGB)
Component Progressive (P)
Component Interlace (I)
• If you select "Component Progressive (P)", proceed
to step 2 below.
• If you select "SCART (RGB)" or "Component
Interlace (I)", your setting is activated.
• Refer to pages 19 and 20 for more details.
2
Using [L / P] to select "Yes". Press
[ENTER].
Activating progressive scan:
Check your TV has progressive scan
and connect with component video cable.
NOTE:
If there is no picture or picture is
distorted after selecting "Yes",
wait about 15 seconds for autorecovery.
Activate?
Final confirmation window will appear.
3
Using [U / D] to select "Yes". Press
[ENTER] within 15 seconds.
Confirm again to use progressive scan.
If Picture is good, select "Yes".
Your setting is activated.
Note
• If your TV is compatible with Progressive Scan
(625p/525p), you must use the Component Video
cable (commercially available) to connect this unit to
the TV.
• When changing the Video Out setting ("SCART
(RGB)", "Component Interlace (I)" or "Component
Progressive (P)"), connect to a VIDEO jack or an
S-VIDEO jack on the TV. If the setting is changed,
for example, to "SCART (RGB)" while the
COMPONENT VIDEO OUT jacks are used to
connect to the TV, a distorted video signal may be
output.
70
EN
Yes No
Yes
No

DivX

®
1
In stop mode, press [SETUP]. Select
"General Setting" using [U / D],
then press [ENTER].
2
Select "DivX" using [U / D], then
press [ENTER].
General Setting
Playback
Display
Video
Recording
Clock
Channel
DivX
Reset All
3
Select the desired item using
[U / D], then press [ENTER].
DivX ® VOD
DivX Subtitle
For DviX VOD, refer to page 45 for details.
®
DivX Subtitle (Default: OFF)
Select the desired setting using
[U / D], then press [ENTER].
DivX Subtitle
OFF
English
French
Spanish
German
Italian
Swedish
4
When you finish with the setting,
press [SETUP] to exit.