To Memorize Channels - Toshiba MW20FP1 Owner's Manual

TV operation

To memorize channels

This unit is equipped with a channel memory feature which allows
channels to skip up or down to the next channel set into memory,
skipping over unwanted channels. Before selecting channels, they
must be programmed into the unit's memory. In addition to normal
VHF and UHF channels, this unit can receive up to 113 cable TV
channels. To use this unit with an antenna, set the TV/CABLE
selection to the TV position. When shipped from the factory, this
selection is in the CABLE position.
TV/CABLE selection
1
Press MENU in the TV mode, then press
to select option.
MENU
ENTER
SETUP
2 Press or to select "TV/CABLE".
ENTER
3
Press or to select "TV" or "CABLE".
TV - VHF/UHF channels
CABLE - Cable TV channels
ENTER
4
Press MENU repeatedly until the menu screen is
cleared.
MENU
SETUP
Cable TV chart
The chart below is typical of many cable system channel
allocations.
26
5L00201C [E]p22-26
or
26
Automatic memory tuning
Press or to select the "AUTO CH MEMORY",
then press .
The TV will begin memorizing all the channels available
in your area.
ENTER
To ADD/DELETE channels
1
Press or to select "ADD/DELETE", then
press .
ENTER
2
Select the desired channel to be added or
deleted using Direct channel selection (0–9), /
or CHANNEL / .
1 2 3
4 5 6
CHANNEL
7 8 9
0
3
Press or to select "ADD" or "DELETE",
whichever function you want to perform.
ENTER
Note:
option if you set the channel to "LINE1"
You can not select
or "LINE2".
20/4/04, 16:05
0–9
CHANNEL /
MENU
ENTER
ADD CH 001
0-9 / / / / / MENU