Maintenance And Inspection - Panasonic AK-HVF100G Operating Instructions Manual

Maintenance and Inspection

[TALLY BRIGHT]
Item
[EXIT]
[UP TALLY]
[FRONT TALLY]
[FOCUS ASSIST]
Item
[EXIT]
[FOCUS-IN-RED] —
[IN-RED-COLOR]
[ZOOM LINK] —
[LINK LEVEL]
[FOCUS ASSIST]
Maintenance and Inspection
Maintenance and inspection are performed with periodic and appropriate maintenance to maintain the function of the unit in constantly good condition
so the customers can use the unit safely.
Make sure to execute the maintenance and inspection for the function of the unit to last long in good condition.
r Periodic maintenance service
The LCD panel is equipped with a backlight. The backlight is a consumable component that deteriorates and eventually breaks down.
Therefore, it is important to perform a periodic maintenance service on top of the conventional service performed at the time of failure. The performance
of the device is maintained in good condition, and unexpected failure due to consumable parts can be avoided by the maintenance service.
34
Returns to the upper level.
Sets the brightness of the up tally lamp.
[HIGH]: Turns on (bright).
[LOW]: Turns on (dark).
[OFF]: Turns off.
f Factory setting: [LOW]
Sets the brightness of the front tally lamp.
[HIGH]: Turns on (bright).
[MID]: Turns on (medium).
[LOW]: Turns on (dark).
f Factory setting: [MID]
Returns to the upper level.
Sets the enable/disable of the function to enhance the part that is focused in the image on this unit.
Disabled while [WFM] is displayed. Disabled when there is no input signal. (setting is canceled when the
power is turned off)
[OFF], [ON]
f Factory setting: [OFF]
Sets the display color of the function to enhance the part that is focused in the image on this unit.
[RED], [GREEN], [BLUE], [WHITE]
f Factory setting: [RED]
Sets the enable/disable of the detail function on the viewfinder linked with the zoom.
[OFF], [ON]
f Factory setting: [OFF]
This item can be operated only when the camera (AK-UC3000G/AK-UC3000GS, AK-HC5000G/
AK-HC5000GS) is connected.
Sets the detail level of the viewfinder linked with the zoom.
[LOW], [MID], [HIGH]
f Factory setting: [LOW]
Sets the enable/disable of the focus assist function on the camera.
[OFF], [ON]
f Factory setting: [OFF]
This item can be operated only when the camera (AK-UC3000G/AK-UC3000GS, AK-HC5000G/
AK-HC5000GS) is connected.
Setting content
Setting content