Table of Contents
Advertisement
11 Maintenance
11.1. Cleaning Methods
THE SCREEN UNIT AND THE MIRROR
-
THE SCREEN UNIT (Lenticular Screen, Fresnel Lens)
It is strongly recommended that the Lenticular Screen surface
(outside) and the Fresnel Lens surface (inside) should be
wiped gently with a clean, soft, dry cloth to remove the dirt.
Note:
1. If the dirt cannot be removed by wiping with a clean, soft, dry
cloth, use a clean, soft, dry cloth moistened with diluted
neutral pH liquid cleanser or a lens cleaner (usually
containing a small amount of ethyl alcohol) and wipe lightly.
Take care not to leave any streaks.
Do not use cleaning materials containing methyl alcohol,
acetone, or dichloromethane.
2. Use an air blower to clean the inner surface of the Lenticular
Screen and the outer surface of the Fresnel Lens (the
surfaces that one another). These surfaces must not be
wiped with a cloth.
-
THE MIRROR
Remove any dirt with an air blower or wipe with a clean, soft,
dry cloth. If wiped too forcefully, the surface of the Mirror can
be damaged. If wiping with a clean, dry cloth does not remove
the dirt, the Mirror must be replaced.
Screen Unit
Lenticular Screen surface
(outside)
Fig. 6-1
THE LAMP
Gently wipe the surface of the glass of the Lamp with cleaning
paper or soft cloth.
Surface of glass
Fig. 6-2
Mirror
Fresnel Lens surface
(inside)
THE FILTER ON THE PROJECTION UNIT
CAUTION:
Operating with torn or damaged Air Filter may cause damage
to the Projection unit.
Remove the Projection Unit from rear. Then, clean the filters on
the Projection Unit. Gently remove any accumulated dust from
filter with a vacuum cleaner; use extreme care so as not to
damage or tear the filters.
Air Filter
<Bottom View>
Air Filter
THE PROJECTION LENS
Use lens cleaning paper and cleaner available at your local
camera shop, etc. Dampen the cleaning paper with cleaner
and gently wipe the surface of the lens from the center outward
to remove dust.
THE LCD PANEL OF THE LCD/PRISM UNIT
1) Clean the surface of the LCD Panel of the LCD/Prism Unit
with an air blower or wipe with a clean, or soft blush lightly.
2) If any dirt remains, lightly wipe the surface with a cotton
swab moistened with pure ethyl alcohol or a lens cleaner
which contains no water or oil. Use a new swab after each
wiping so that dirt will not be re-deposited on the surface.
105
PT-52LCX66-K / PT-56LCX16-K / PT-61LCX66-K
Air Filter
Fig. 6-3
Lens
Fig. 6-4
Advertisement
Table of Contents
