Panasonic AK-HVF100G Operating Instructions Manual page 33

Item
[SHARPNESS MODE]
[SHARPNESS H]
[SHARPNESS V]
[MONO]
[SCAN]
[BACK LIGHT]
[SYSTEM CONFIG]
Item
[EXIT]
[WFM]
[WFM POSITION]
[TALLY ASSIGN]
[MENU RESUME]
[POWER LED]
[STATUS DISPLAY]
[HOUR METER]
Item
[EXIT]
[OPERATION]
[LCD]
Selects the edge width of the contour correction (during peaking).
[HIGH]: Narrow edge
[LOW]: Wide edge
f Factory setting: [HIGH]
Sets the horizontal contour correction.
Adds to the operation of the <PEAKING> knob.
[0]...[30]
f Factory setting: [0]
Sets the vertical contour correction.
Adds to the operation of the <PEAKING> knob.
[0]...[30]
f Factory setting: [0]
Switches between color and monochrome.
[OFF]: Color.
[ON]: Monochrome.
f Factory setting: [OFF]
Sets the underscan or normal display of the screen.
[NORMAL]: Normal display.
[UNDER]: Underscan.
f Factory setting: [NORMAL]
Adjusts the brightness of the LCD backlight.
[0]...[100]
f Factory setting: [100]
Returns to the upper level.
Sets if the waveform of the video signal input to viewfinder is displayed or not.
[FOCUS-IN-RED] is disabled when [WFM] is displayed while [FOCUS-IN-RED] is enabled.
[OFF]: Not displayed.
[WFM]: Displays the waveform of the brightness signal.
f Factory setting: [OFF]
Selects the position of the waveform display when [WFM] is [ON].
[LB]: Bottom left of the screen.
[RB]: Bottom right of the screen.
[RT]: Top right of the screen.
[LT]: Top left of the screen.
f Factory setting: [RB]
Sets the illumination condition of the assignable tally lamp.
[OFF]: Turns off.
[INPUT SDI]: Turns on when the <INPUT> switch is set to <SDI>.
[INPUT CAM]: Turns on when the <INPUT> switch is set to <CAM>.
[CAM MENU]: Turns on when the menu operation function of the camera is enabled. Only when the
camera (AK-UC3000G/AK-UC3000GS, AK-HC5000G/AK-HC5000GS) is connected.
f Factory setting: [OFF]
Sets the enable/disable of the menu resume function.
[OFF], [ON]
f Factory setting: [OFF]
Sets the illumination condition of the <POWER> lamp.
[ON]: Turns on continuously.
[OFF1]: Turns off (setting will return to [ON] when the power is turned off/on).
[OFF2]: Turns off continuously.
f Factory setting: [ON]
Sets the display condition of the status display.
[CONTINUE]: Displays continuously.
[3SEC OFF]: Displays for three seconds after changing the condition of the status display, and then
disappears.
[OFF]: Not displayed.
f Factory setting: [3SEC OFF]
Returns to the upper level.
Displays the total number of hours the power was turned on.
Hours up to 262800 hours [262800H] (approximately 30 years) is displayed. Hours exceeding 262800
hours is displayed as [OVER].
Displays the number of hours the backlight has been on.
Hours up to 262800 hours [262800H] (approximately 30 years) is displayed. Hours exceeding 262800
hours is displayed as [OVER].
Setting content
Setting content
Setting content
Menu operations
33