TEC EM1-31071 Owner's Manual page 89

16. ERROR MESSAGE TABLE
Label Issue Mode
Message
DATA ENTRY ERROR
PLU NOT FOUND
TOTALS OVERFLOW
MEMORY WILL FULL
PLU DATA ERROR
PRT FAILURE
LABEL OVER RUN
Read and Reset Mode
Message
PLU NOT FOUND
PRT FAILURE
LABEL OVER RUN
Cause
Error in key input.
The PLU # being called is not
registered.
GRAND TOTAL or PLU TO-
TAL memory has been ex-
ceeded at the time of issuing a
label.
The machine judges the
memory is full before desig-
nated number of media are
printed in Batch mode.
Error in the PLU data.
Printer trouble.
Media end.
Label overruns.
Cause
Corresponding PLU # is not
registered.
Printer trouble.
Label overruns.
16-2
16. ERROR MESSAGE TABLE
Solution
Press the C key, and re-input the
right data.
Press the C key, and check the
PLU #.
Press the C key, then the ESC.
key and select 'RESET'. Then sum
up the exceeded memory.
Press the C key, then the ESC.
key and select 'RESET'. Then sum
up the exceeded memory.
Press the C key, and reprogram
PLU data.
1. Check that the label and print
head are set correctly.
2. If the label home position is
misaligned, press the FEED
key.
Press the FEED key.
Solution
Press the C key, and enter the
correct PLU #.
Same as in the label issue mode.
Press the FEED key.