Ingredient Message - TEC EM1-31071 Owner's Manual

11. PROGRAMMING PROCEDURES
11.3

INGREDIENT MESSAGE

Menu Group: 1
Item No.:
Ingredient messages can be printed on a label with a maximum of 54 characters per line in small
letters or 32 characters per line in boldfaced small letters, by up to 38 lines.
<MENU>
Group 1
Enter the ingredient message
(Refer to Page 11-3.)
Pressing the
calls data stored by pressing
the
Pressing the
temporarily stores data into
the work buffer.
NOTES: 1. When no data is programmed for the PLU, ingredient cannot be set.
2. When a selected PLU is not stored in the PLU file, a "PLU NOT FOUND" error occurs.
3. Once you exit this menu and enter again, data stored in the work buffer is cleared.
4. When there is no area to store ingredient data, a "MEMORY FULL" error occurs.
5. PLUs cannot share ingredient data. (PLU and ingredient data are in pairs.)
2
C
2
NEXT
PLU
RECEIVE
key
SEND
key.
SEND key
Enter the PLU#
(max. 6 dig.)
or
ENTER
The memory file
is sorted when a
memory full error
occurs.
11-7
11.3 INGREDIENT MESSAGE
ENTER
C
TEST
Sorting
Y
Any key
except Y
Not Sorting
<MENU>
PROG.
Group 1
Main
ESC.
<MENU>