Programming; Home Screen - Pentair FLECK 5800 XTR Installer Manual

Installer manual Fleck 5800 XTR - Programming
6

Programming

6.1

Home screen

12:01 am
Info
If no button is pushed for five minutes, the screen will enter a power save mode. The
unit will continue to operate, but the screen will be blank. Touch anywhere on the
screen to exit power save mode.
Not all buttons appear on all screens.
1 Regeneration
2 Settings
3 Diagnostics
4 Assistance
5 Vacation
6 Regeneration
cycle wheel
50 / 126
Water Treatment
wed
treatment
tank refill
rapid rinse
• Displays the regeneration screen, which allows you to start a
regeneration and manually cycle through the regeneration
steps.
• Displays the settings screen, which allows you to adjust
commonly used settings. Pressing this button while in the
settings screen provides access to the master settings
screen, which allows you to fully program the valve.
• Displays the diagnostics screen, which can assist in
performing maintenance and troubleshooting performance
issues with the valve.
• Displays a name and phone number to call for unit service.
• Halts all scheduled regenerations when pressed; press again
to resume normal operation.
• Displays the cycle steps the valve will step through during
service and regeneration; the current cycle step is always
shown on green.
4.5
m³
backwash
draw
Ref. MKT-IM-006 / E - 12.11.2019