Viewing The Digital Signal Meter; Viewing The System Status - Toshiba TheaterWide 46HM95 Owner's Manual

Viewing the digital signal meter

You can view the digital signal meter for the ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
Setup
Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio Auto
HDMI 2 Audio Auto
Slide Show Interval 2 Sec
AVHD Skip Time 15 min
Navigate Select CH RTN
3. Open the Terrestrial menu, highlight Signal Meter, and
press ENTER.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
Navigate Select CH RTN
4. Use the yzx • buttons to select the antenna input and
digital channel whose signal you want to check.
Note: The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV channel
number. Contact your local broadcasters to obtain the RF
channel numbers for your local digital stations.
Signal Meter
Signal Locked
0
Antenna
Physical Digital Channel
Virtual Digital Channel N/A
O K
To close the screen and return to the Terrestrial menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.
52
HM95_R1_044-52_061505 52
Black
Chapter 6: Setting up your TV
Back EXIT Exit
Back EXIT Exit
Peak 0
1
13
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Viewing the system status

To view the system status:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown
below right).
Setup
Installation
Sleep Timer
On/Off Timer
HDMI 1 Audio Auto
HDMI 2 Audio Auto
Slide Show Interval 2 Sec
AVHD Skip Time 15 min
Navigate Select CH RTN Back EXIT Exit
3. Open the System Status menu, highlight System
Information, and then press ENTER.
4. Use the x • buttons to scroll through the menu bar to
check the Product Information and Software Version.
System Information
Product Information
Brand: Toshiba
Model: 52HM95
IEEE1394 GUID: 00003914-28343803
O K
To close the screen and return to the Installation menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.
Restore Factory Defaults
To restore all settings and channels to their factory default
values:
1. Follow steps 1–3 above.
2. Use the x • buttons to scroll through the menu bar to
select Factory Defaults.
3. Enter your PIN code (or 0000 if no PIN code has been set).
4. Highlight Yes and press ENTER. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the restore process.
To cancel the reset:
Highlight No and press ENTER.
6/24/05, 9:48 PM
System Status
System Infomation
Navigate Select CH RTN Back EXIT Exit
System Information
Software Version
0.3.0
Mar 9 2005 - 12:37:10
FW:0.12
Sub:47
O K