Viewing The Digital Signal Meter; Viewing The System Status - Toshiba 56MX195 Owner's Manual

Viewing the digital signal meter

You can view the digital signal meter for ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
HDMI 1 Audio
HDMI 2 Audio
Slide Show Interval
Navigate
3. Open the Terrestrial menu, highlight Signal Meter, and
press ENTER.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
Navigate
4. Use the yzx • to select the antenna input and digital
channel whose signal you want to check.
Note: The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV channel
number. Contact your local broadcasters to obtain the RF
channel numbers for your local digital stations.
Signal Meter
Signal Locked
Antenna
Physical Digital Channel
Virtual Digital Channel
Done
To close the screen and return to the Terrestrial menu:
Highlight DONE and press ENTER.
To return to normal viewing:
Press EXIT.
Downloaded from www.Manualslib.com
Auto
Auto
2 Sec
Select CH RTN Back EXIT Exit
Select CH RTN Back EXIT Exit
0
Peak
0
1
13
N/A
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
manuals search engine
Chapter 6: Setting up your TV

Viewing the system status

To check the system status:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown
below right).
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
HDMI 1 Audio
HDMI 2 Audio
Slide Show Interval
Navigate
3. Open the System Status menu, highlight System
Information, and then press ENTER.
4. Use the x • to scroll through the menu bar to check the
Product Information and Software Version.
System Information
IEEE1394 GUID:
To close the screen and return to the Installation menu:
Highlight DONE and press ENTER.
To return to normal viewing:
Press EXIT.
Restore Factory Defaults
To restore all settings and channels to their factory default
values:
1. Follow steps 1–3 above.
2. Use the x • to scroll through the menu bar to select
Factory Defaults.
3. Enter your PIN code (or 0000 if no PIN code has been set).
4. Highlight Yes and press ENTER. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the restore process.
System Information
To cancel the reset:
Highlight No and press ENTER.
System Status
System Infomation
Auto
Auto
2 Sec
Select CH RTN Back EXIT Exit Navigate
System Information
Product Information
Brand: Toshiba
Model: 62MX195
00003914-28343803
Done
Press YES to confirm. After the TV
turns off, unplug it and plug it dack
in to complete the reset.
Yes No
Select CH RTN Back EXIT Exit
Software Version
0.3.0
Mar 9 2005 - 12:37:10
FW:0.12
Sub:47
Done
57