Tuning Your Favorite Channels; Tuning To The Next Programmed Channel; Tuning To A Specific Channel (Programmed Or Unprogrammed); Switching Between Two Channels Using Channel Return - Toshiba TheaterWide 46HM95 Owner's Manual

Tuning channels

Tuning your favorite channels

To tune to the channels you programmed as Favorite Channels,
see page 44.

Tuning to the next programmed channel

To tune to the next programmed channel:
Press CHANNEL y or z on the remote control or TV front
panel.
Note:
• This feature will not work unless you program channels into the
TV's channel memory (see page 42).
• If you are recording a digital channel, you will only be able to
change analog channels while the recording is in progress. If you
are recording an analog channel, you will only be able to change
digital channels while the recording is in progress. This is
because the TV tuner that is being recorded (digital or analog)
will be locked on the channel that is currently recording.
Tuning to a specific channel
(programmed or unprogrammed)
Tuning analog channels:
Press the Channel Number buttons (0–9) on the remote
control. For example, to select channel 125, press 1, 2, 5.
Tuning digital channels:
Press the Channel Number buttons (0–9) on the remote
control, followed by the – (dash) button and then the sub-
channel number. For example, to select digital channel 125-1,
press 1, 2, 5, –, 1.
Note: If a digital channel is not programmed—either through
the automatic channel scan (page 42) or the channel add/
delete function (page 43)—you will have to tune the RF
channel using the Channel Number and Dash buttons on the
remote control.
HM95_R2_067-78_062705 71
Chapter 8: Using the TV's features
(continued)
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Switching between two channels using
Channel Return
The Channel Return feature allows you to switch between two
channels without entering an actual channel number each time.
1. Select the first channel you want to view.
2. Select a second channel using the Channel Number buttons
(and the dash (–) button if selecting a digital channel).
3. Press CH RTN on the remote control. The previous
channel will display. Each time you press CH RTN, the TV
will switch back and forth between the last two channels
that were selected.
Note:
• If you press CH RTN from a non-antenna input, the TV will
return to the last-viewed ANT input and channel.
• If you are currently recording a program, this feature will not
be available.
Switching between two channels using
SurfLock™
The SurfLock ™ feature temporarily "memorizes" one channel in
the CH RTN button, so you can return to that channel quickly
from any other channel by pressing CH RTN.
To memorize a channel in the CH RTN button:
1. Select the channel you want to program into the CH RTN
button.
2. Press and hold CH RTN for about 2 seconds until the
message "Channel Memorized" appears on the screen. The
channel has been programmed into the CH RTN button.
3. You can then change channels repeatedly, and when you
press press CH RTN, the memorized channel will be
selected.
The TV will return to the memorized channel one time only.
Once you press CH RTN and then change channels again, the
CH RTN memory will be cleared and the button will function
as Channel Return, by switching back and forth between the last
two channels that were selected.
CH RTN
6/27/05, 8:06 PM
Channel Numbers
— (dash)
CHANNEL yz
71