Table of Contents
Advertisement
Viewing the digital signal meter
You can view the digital signal meter for ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below.)
Setup
Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection
Auto
Side Show Interval
2 Sec
AVHD Skip Time
15 min
Convergence
DVD RTN
Navigate
Select
Back
CH RTN
3. Open the TERRESTRIAL menu, highlight SIGNAL
METER, and press ENTER.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
DVD RTN
Navigate
Select
Back
CH RTN
4. Use the yzx • buttons to select the antenna input and
digital channel whose signal you want to check.
Note: The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV channel
number. Contact your local broadcasters to obtain the RF
channel numbers for your local digital stations.
Signal Meter
Signal Locked
78
Peak
Antenna
Physical Digital Channel
Virtual Digital Channel
OK
To close the screen and return to the TERRESTRIAL menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.
52
51,57HX94(E)044-52
52
Chapter 6: Setting up your TV
Exit
EXIT
Exit
EXIT
78
1
56
N/A
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
Viewing the system status
To check the system status:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3).
3. Open the SYSTEM STATUS menu, highlight SYSTEM
INFORMATION, and then press ENTER.
Setup
Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection
Auto
Side Show Interval
2 Sec
AVHD Skip Time
15 min
Convergence
DVD RTN
Navigate
Select
Back
Exit
EXIT
CH RTN
4. Use the x • buttons to scroll through the menu bar to
check the Product Information and Software Version.
To close the screen and return to the INSTALLATION
menu: Highlight OK and press ENTER.
To return to normal viewing: Press EXIT.
Restore Factory Defaults
To restore all settings and channels to their factory default
values:
1. Follow steps 1–3 above.
2. Use the x • buttons to scroll through the menu bar to
select FACTORY DEFAULTS.
3. The screen below left appears. Enter your PIN code (or
0000 if no PIN code has been set). The screen below right
appears.
To cancel the reset: Highlight NO and press ENTER.
To continue the reset process: Highlight YES and press
ENTER. The TV will turn off automatically after a few
seconds. After the TV turns off, unplug the TV power cord
and then plug it in again to complete the restore.
System Information
Factory Defaults
This window provides the ability to reset
the TV settings.
Type in your PIN now (or "0000" if no PIN
has been set) to restore settings to their
factory default values.
OK
9/12/04, 7:11 PM
System Status
System Infomation
DVD RTN
Navigate
Select
Back
Exit
EXIT
CH RTN
System Information
Factory Defaults
This window provides the ability to reset
!
Press YES to confirm. After the TV
the TV settings.
turns off, unplug it and plug it
Type in your PIN now (or "0000" if no PIN
back in to complete the reset.
has been set) to restore settings to their
Yes
No
factory default values.
OK
Hide quick links:
Advertisement
Table of Contents
