Loading The Ribbon - Toshiba B-SA4TP Series Instructions Manual

13. Change the print head pressure according to the
thickness of the media to be used, by using the Head
Position Lever.
NOTES:
1. Be sure to set both Head Position Levers in the same
direction. Failure to do this may cause blurred
printing.
2. Do not leave the Head Position Levers positioned at the
middle. When closing the Top Cover, they block the
Print Head Positioning Shaft, and the Top Cover cannot
be closed.
14. If the loaded media is direct thermal media (with a
chemically treated surface), the media loading
procedure is now completed. Close the Top Cover.
If the media is normal media, it is also necessary to
load a ribbon.

2. LOADING THE RIBBON

1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being drawn into
the moving parts, be sure to load the ribbon once the printer has stopped moving completely.
2. The print head becomes hot immediately after printing. Allow it to cool before loading the ribbon.
3. To avoid injury, be careful not to trap your fingers while opening or closing the cover.
1. Ne touchez à aucune pièce en mouvement. Assurezvous que l'impression s'est complètement
arrêtée avant de charger le média, afin de réduire le risque d'avoir vos doigts, vos bijoux ou vos
habits entraînés dans le mécanisme.
2. La tête chauffe beaucoup en imprimant. Laissez-la refroidir avant de charger le film.
3. Pour éviter les blessures, faites attention de ne pas vous pincer les doigts en ouvrant ou en
fermant le capot.
Be careful not touch the Print Head Element when opening the Top Cover. Failure to do this may cause
missing dots by static electricity or other print quality problems.
Faites attention de ne pas toucher la tête d'impression en ouvrant le capot supérieur. De l'électricité statique
pourrait endommager la tête ou entraîner des problèmes de qualité d'impression
NOTE:
When replacing the ribbon, leave the printer power on. Then, press the [RESTART] key to restart an operation.
Print Head
Positioning Shaft
Head Position Lever
WARNING!
AVERTISSEMENT!
CAUTION!
ATTENTION !
7
Head Position Lever
Head Position Lever
Media type or thickness
Label or Thin media
If a clear print cannot be obtained,
change the position to .
Tag paper or Thick paper
If a clear print cannot be obtained,
change the position to .
Head Position
Lever
Move the levers
toward the front
of the printer.
Move the levers
toward the back
of the printer