Commissioning Snmp; Led Indicators; Rs232 Interface; Activated Ports - Siemens SWT-3000 Equipment Manual

SNMP and Remote Access

Commissioning SNMP

LED Indicators

The following LED indicators are located on the top panel of the SNMP terminal adapters.
Table 2:
LED Name
Ready
P1/P2 (Tx)
P1/P2 (Rx)

RS232 interface

Table 3:

Activated ports

IP Address

Figure 9:
Page - 16
LED indicators
LED Colour LED Function
Green Power is on and functioning normally
Green Serial port 1 / 2 is transmitting
Off Serial port 1 / 2 is not transmitting
Yellow Serial port 1 / 2 is receiving data
Off Serial port 1 / 2 is not receiving data
Pin assignment of the Sub D connector
Pin RS232
1 DCD
2 RxD
3 TxD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
Adjustment of the IP address
Edition p3_3_2x 08/09
SWT 3000 Equipment Manual
All SNMP server are delivered with the default
IP address: 192.168.3.127 at LAN port 1.
The connected Service PC has to be adjusted
to an IP address in the same network like
192.168.3.1:
© SIEMENS AG 2008