Parts Supplied; Prior To Installation; After Installation - Fisher & Paykel OB30S Installation Manual

Hide thumbs Also See for OB30S:
Table of Contents

Advertisement

Available languages

Available languages

Screws
Spacers
Single oven models (2)
Single oven models (2)
Double oven models (4)
Double oven models (4)
IMPORTANT!
Some environmental factors and cooking habits can cause condensation in and around the oven during use. To protect surrounding cabinetry from possible damage caused by
frequent or excessive condensation, we recommend moisture-proofing the oven cavity.
the countertop and oven cavity are square and level, and are the required dimensions.
z
the installation will comply with all clearance requirements and applicable standards and regulations.
z
the isolating switch will be easily accessible to the customer with the oven installed.
z
the electrician provides sufficient free length of power supply cable to reach from the bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening.
z
the cable may enter the cavity from the side, top or bottom, but top entry must be at the rear of the cavity.
z
the oven connection socket (if fitted) is outside the cavity if the oven is flush to the rear wall.
z
the oven will rest on a surface that can support its weight.
z
the height from the floor suits the customer.
z
you consult local building authorities and by-laws if in doubt regarding installation.
z
IMPORTANT!
Please take extra care not to damage the lower trim of the oven during installation. The trim is important for correct air circulation and allows the
door to open and close without obstruction. The manufacturer does not accept any responsibility for damage resulting from incorrect installation.
the oven door(s) can open fully without obstruction.
z
do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult. Fisher & Paykel will not cover the costs of
z
removing the oven, or of damage caused by this removal.
the power supply cable does not touch any hot metal parts.
z
the isolating switch is easily accessible to the customer with the oven installed.
z
you complete the 'Final checklist' at the end of the installation.
z
if, after following the instructions given, correct performance cannot be achieved, please contact your nearest Fisher & Paykel Authorized Service
z
Center, Customer Care, or contact us through our local website listed at the end of this document.

PARTS SUPPLIED

Long Trim (1)
To be fitted in
a flush installation.

PRIOR TO INSTALLATION

AFTER INSTALLATION

3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ob30d

Table of Contents