Parts Supplied; Prior To Installation; After Installation - Fisher & Paykel OB60SC Installation Manual

Screws (2) Metal side shelves
fixing nut (2)
the benchtop and oven cavity are square and level, and are the required dimensions.
● ●
the installation will comply with all clearance requirements and applicable standards and regulations.
● ●
a suitable isolating switch providing full disconnection from the mains power supply is incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and
● ●
regulations. The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this
variation of the requirements).
the isolating switch will be easily accessible to the customer with the oven installed.
● ●
there is at least 1.5 m (and not more than 2 m) free length of power supply cable within the cavity for ease of installation and servicing.
● ●
the oven connection socket (if fitted) is outside the cavity if the oven is flush to the rear wall.
● ●
the oven will rest on a surface that can support its weight.
● ●
the height from the floor suits the customer.
● ●
you consult local building authorities and by-laws if in doubt regarding installation.
● ●
Lower trim kit (for compact models only)
compact models can be installed with a lower trim kit accessory to align the oven with companion products and cabinetry. If installing the lower trim kit accessory, ensure that this is installed
● ●
before the appliance.
IMPORTANT!
Some environmental factors and cooking habits can cause condensation in and around the oven during use. To protect surrounding cabinetry from possible damage caused by frequent or
excessive condensation, we recommend moisture-proofing the oven cavity.
IMPORTANT!
Please take extra care not to damage the lower trim of the oven during installation. The trim is important for correct air circulation and allows the door to open and close without
obstruction. The manufacturer does not accept any responsibility for damage resulting from incorrect installation.
the oven door can open fully without obstruction.
● ●
the power supply cable does not touch any hot metal parts.
● ●
the isolating switch is easily accessible to the customer with the oven installed.
● ●
you complete the 'Final checklist' at the end of the installation.
● ●
If, after following the instructions given, correct performance cannot be achieved, please contact your nearest Fisher & Paykel Authorised Service Centre, Customer Care, or contact us through
● ●
our local website listed at the end of this document.
2

PARTS SUPPLIED

3

PRIOR TO INSTALLATION

4

AFTER INSTALLATION

2