First-Time Connection Considerations - Extron electronics DMS 1600 Setup Manual

5. Follow the on-screen instructions. The installation program creates
a C: \ Program Files \ Extron \ Matrix _ Switchers directory and an
"Extron Electronics\Matrix Switchers" group folder. It installs the
following four programs:
•
MATRIX Switcher+ Control Program
•
MATRIX Switcher+ Help
•
Uninstall MATRIX Switcher
•
Check for Matrix Updates

First-time Connection Considerations

LAN port connection
If you connect your PC to the switcher via the LAN port, and it is the first
time you have done so, you may need to change the default settings (IP
address, subnet mask, and [optional] administrator password) on the
controller (see
for details.)
NOTE:
device have been set to the device serial number. In the event of
a complete system reset, the passwords convert to the default,
which is no password.
USB port connection
When you connect your PC to the DMS matrix switcher via the USB port
for the first time, the Found New Hardware Wizard opens.
Activate the connected USB port for your device as follows:
NOTE:
Program, click Cancel and install the program. Reconnect the
switcher to the PC via the Configuration port (see
Program
20 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control
Configuring for Network Communication
The factory configured passwords for all accounts on this
1 1 1 1 1 1 1 1 1 1
If you have not installed the latest Matrix Switchers Control
on page 19).
1 1 1 1 1 1 1 1 1 1
on page 23
Installing the