Saeco 10001872 Operating And Maintenance Manual page 44

CLEANING THE BREW GROUP
The brew group must be cleaned at least once a week.
Lubricate the brew group after approximately 500 brewing cycles. The brew group lubricant may be
purchased directly from Saeco or any authorized service center.
Wash the brew group with warm water.
WARNING! Do not wash the brew group with detergents that can compromise its correct operation. Do
not wash in the dishwasher.
1
Press to open the service door.
4
Wash the upper fi lter with
running water.
7
The lever on the rear part of
the group must be in contact
with the group base.
2
Press the PUSH button to remove
the brew group.
5
Make sure the brew group is in
rest position; the two references
must match.
8
Lubricate the brew group guides
only with the supplied lubricant.
3
Wash any coffee residues from
the brew group.
6
Make sure the components are in
the correct position. The hook
shown must be in the correct
position; to check its position,
fi rmly press the "PUSH" button.
9
Apply the lubricant evenly.
41