Caution:
In operating environments where the ambient temperature is above 40C, the metal surfaces
on the AL7018005–E6 FI cables can become hot. Use caution when removing or handling
hot equipment.
Base unit
The base unit switch is located on the front panel of the switch. Use the base unit switch to
designate a unit in the Stack as the Base unit. Slide the base unit switch to the down position
to designate a unit as the Base unit. You must designate only one switch in a Stack as the
Base unit. The base unit switch of all the other non-base units (NBU) in the Stack must be in
the up position. You can verify the Base unit from the base unit switch position and Base LED
display on the front status panel.
VSP 7000 installation
Base unit
July 2013
45