Avaya Virtual Services Platform 7000 Series Installation Manual page 40

Switch installation
40 VSP 7000 installation
LED
Emerald (Solid)
Emerald (Blinking)
Status Off
Amber (Solid)
Amber (Blinking)
Emerald (Solid)
Emerald (Blinking)
Up / Down Off
Amber (Solid)
Emerald (Solid)
Emerald (Blinking)
PS1 / PS2 Off
Amber (Solid)
Comments? infodev@avaya.com
State
The unit is operating as the Base
unit in a Stack.
The unit joined the Stack and
Automatic Unit Replacement is
upgrading the diagnostics, agent, or
configuration file.
The unit is not operating.
The unit encountered an error
during diagnostics.
The unit is booting. During boot the
unit executes the boot loader and
diagnostics.
The unit is operating normally.
Agent software is loaded.
The unit is loading the agent
software.
The FI Up / Down cable is not
detected or connected to an
adjacent unit.
The FI Up / Down cable is detected
and connected to an adjacent unit,
but adjacency with the neighbor is
not complete.
The FI Up / Down cables are
detected and connected to an
adjacent unit. Adjacency with the
neighbor is complete.
The unit formed a partial neighbor
with an adjacent unit. Check the FI
Up / Down cable connections.
Note:
If rear port mode is enabled, both
Up and Down LEDs blink
Emerald in synchronization. The
Base LED is off.
The power supply in slot 1/2 is not
connected to a power source.
The power supply in slot 1/2 is
removed after operating (Non-
Service Effecting).
Description
July 2013