Tachometer Settings - Calibration - Mercury SC 1000 Operation And Maintenance Manual

SCREENS
ACTIVE TRIM SCREEN ?
( NO )
(SAVE)
SPORT EXH. SCREEN ?
( NO )
(SAVE)
REMOTE SCREENS ?
[ NO ] [SAVE]
HIGH RESOLUTION TRIM ?
[ NO ] [SAVE]
TRIM POPUP ?
[ NO ] [SAVE]
SCREENS
EXIT ?
[ NO ] [ YES ]
Tachometer Settings ‑ CALIBRATION
1. Press the "MODE/SELECT" and "+" buttons simultaneously for
approximately six seconds or until the "CALIBRATION" screen appears.
2. Press the "+" or "–" to change the settings.
CALIBRATION
CALIBRATION
FUEL TANK 1 CAPACITY
CAPACITY = 26.2 G
[DOWN] [SAVE]
eng
SC 1000 TACHOMETER
The active trim screen is displayed "YES" for
on or "NO" for off. This screen requires
additional hardware/software in order to
( YES )
function.
67158
The sport exhaust screen is displayed "YES"
for on or "NO" for off. This screen requires
additional hardware/software in order to
( YES )
function.
67159
Allows all SC 1000 tachometers that are
enabled (YES) to show the same screen.
When station 1 tachometer has depth on the
[ YES ]
screen, station 2 tachometer will show the
52645
same screen.
Enables the trim angle to be displayed in 0.1°
increments if "YES" is selected.
[ YES ]
23621
The trim display screen pops up when the trim
setting is changed if "YES" is selected.
[ YES ]
23641
Select "NO" to go through the screen selection
again, "YES" to exit the screens, or "CAL" to
calibrate the tank levels. Refer to Fuel Tank
[CAL ]
Calibration.
52646
Enter the capacity of the tank. Select "DOWN"
or "UP" to set the tank capacity. Then press
[ UP ]
"SAVE." This option is the same for tanks.
52647
19