Sc 1000 Speedometer; Speedometer Display Screens - Mercury SC 1000 Operation And Maintenance Manual

Speedometer Display Screens

NOTE: Depending on the engine model and vessel options, not all screens will
apply.
1
70
F
AIR
2
FUEL 1
E
3
FUEL 2
E
4
PORT
INST
1.5
5
RESET
When the ignition is turned on, the speedometer will show the last screen that
was displayed before the ignition was turned off.
Press "MODE/SELECT" to change display screens. Revert back to the
previous screen by pressing and holding "MODE/SELECT" for two seconds.
NOTE: Readings can be displayed in English (U.S.) or metric. Refer to
Speedometer Screens
NOTE: The descriptions may not be in order on the gauge. The order may
change depending on engine type.
1. Clock ‑ Temp: Clock, air temperature, and water temperature. The air
and water temperature sensors must be connected to obtain display
readings.
2. Fuel 1: Displays the amount of fuel remaining in fuel tank 1.
3. Fuel 2: Displays the amount of fuel remaining in fuel tank 2, water/waste
tank level (if applicable.) This screen will automatically display engine oil
tank for an OptiMax outboard.
4. Tabs: Shows the position of the port and starboard tab viewed as a
percentage.
5. Fuel Economy: Displays the average "AVG" fuel consumption as well as
instantaneous "INST" fuel economy. The numbers displayed indicate
miles per gallon "M/G" or kilometers per liter "KM/L." Fuel Reset: To
reset, select the display screen, press "MODE/SELECT" and "–"
simultaneously.

SC 1000 SPEEDOMETER

5:30
PM
60
F
SEA
90
GAL
110
GAL
TABS
0% 0%
STBD
M/G AVG
3.2
.
F
20
10
0
F
26
40
30
50
60
70
80
SPEED
46451
eng