Speedometer Settings - Screens - Mercury SC 1000 Operation And Maintenance Manual

MENU
LOCAL LIGHT
[DOWN] [SAVE]
Speedometer Settings ‑ SCREENS
This calibration turns the system display screens on and off.
NOTE: Depending on the engine model and vessel options, not all screens will
apply.
1. Press the "MODE/SELECT" and "+" buttons simultaneously for
approximately four seconds until "SCREENS" is the display screen.
2. Press the "–" or "+" button to select the option choice displayed in the [ ]
brackets on the screen.
3. Press "MODE/SELECT" to save the setting and advance through the
calibration selections.
SCREENS
TO WAYPOINT SCREEN ?
YES
( NO ) ( SAVE )
WAYPOINT ALARM ?
YES
( NO ) ( SAVE )
WAYPOINT ALARM
DISTANCE = 0.3 MILES
( DOWN ) ( SAVE )
STEERING ANG. SCREEN ?
YES
[ NO ] [SAVE]
TEMP/CLOCK SCREEN ?
YES
[ NO ] [SAVE]
SC 1000 SPEEDOMETER
Allows you to control the light level of the local
screen.
[ UP ]
52644
To waypoint screen is displayed "YES" for on
or "NO" for off. GPS screens must be turned
( YES )
on for this screen to be activated.
46462
Waypoint alarm is displayed "YES" for on or
"NO" for off. GPS screens must be turned on
( YES )
for this screen to be activated.
46463
Set the distance from the waypoint when the
alarm will become active. Press the "–" button
to decrease the distance or "+" to increase the
( UP )
distance. The default distance setting is 0.3
46464
mile
The steering angle is displayed "YES" for on or
"NO" for off.
[ YES ]
23542
The split screen showing air temperature and
time is displayed "YES" for on or "NO" for off.
[ YES ]
23543
30
eng