Table of Contents
Advertisement
PROGRAM MODE
Mode No.
A3/DLT
Double Count
27
Auto Sort
Select
28
Fusing
Temperature
29
Control
Selection
Toner Supply
Mode Selection
30
Toner Supply
Amount
(TD Sensor
31
Mode)
Specifies whether the counter is doubled for A3/DLT
paper.
If "ON" is selected, the total counter, electrical total
counter (SP88), and the current user code counter
count up twice when A3/DLT copy paper is used.
This function is not applicable when using the
by-pass feed table, since the by-pass feed table can
not detect copy paper size.
In Auto Sort Mode, the sorter is automatically
selected when more than 1 original is set on the DF
table and the entered copy quantity is greater than 1
and less than 11.
In Manual mode, sort mode has to be selected at
the operation panel.
The sorter and DF must be installed on the machine.
Selects the fusing temperature control mode.
After selecting the control mode and turning the
main switch off/on, the fusing temperature control
mode is changed.
Selects the toner supply system.
Normally, this value should not be changed.
SP
Toner Supply System
Setting
Detect supply mode using
0
the initial TD sensor
setting.
Detect supply mode using
1
the target TD sensor
voltage set with SP53.
Detect supply mode (fixed
2
amount) using the initial
TD sensor setting.
Detect supply mode (fixed
amount) using the target
3
TD sensor voltage set
with SP53.
Fixed supply mode.
4
See SP31/SP32 for the toner supply amount.
Determines how much toner is supplied in detect
supply mode.
Select the toner supply time from 0.0 s to 5.0 s in
0.1 s steps.
See "Detailed Descriptions-Toner Supply Control"
for more details.
Function
Note
Default
Use only in abnormal TD
sensor conditions.
28
26 September 1997
Settings
0: OFF
1: ON
0: Manual
1: Auto Sort
0: ON/OFF
control
1: Phase
control
Default = 0
0 ~ 50
Default = 4
(0.4 s)
Advertisement
Table of Contents
