Electric Cutting Unit Motor Adapter - Toro Greensmaster eTriFlex 3360 Service Manual

Electric Cutting Unit Motor Adapter

Removing and Installing the Cutting Unit Motor Adapter
DPA Cutting Units: Service and Repairs
g285260
1. Hex nut (2 each)
2. Motor adapter
3. Socket head screw (2 each)
Refer to Figure 162 for this procedure.
1. Remove the electric motor from the cutting unit and move it to the storage
location at the front of the cutting unit suspension.
2. Remove the motor adapter from the cutting unit side plate.
Note: The lock nuts are captured in the back side of the side plate.
3. Remove the large O-ring and the 2 small O-rings from the motor adapter.
Discard the large O-ring.
4. Lubricate a new large O-ring with grease and install in on the motor adapter.
5. Install the 2 small O-rings in the motor adapter without lubrication. Ensure
the O-rings are correctly positioned in the motor adapter grooves.
6. Install the motor adapter to the cutting unit side plate and install the electric
cutting unit motor.
Figure 162
4. Motor clamp
5. O-ring
6. O-ring (2 each)
Page 7–22 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B