Charging The Lithium-Ion Batteries (Model 04590); Servicing The Lithium-Ion Batteries (Model 04590) - Toro Greensmaster eTriFlex 3360 Service Manual

Charging the Lithium-Ion Batteries (Model 04590)

Servicing the Lithium-Ion Batteries (Model 04590)

Removing and Installing the Lithium-Ion Batteries (Model 04590)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
Refer to the Traction Unit Operator's Manual for battery charging and battery
charger operation information. Refer to Battery Charger Error and Fault Codes in
this manual for battery charger troubleshooting information.
Note: A record of battery charger operation data can be downloaded by inserting
a flash drive into the USB port on the battery charger. Forward a copy of the
battery charger data file to Toro Service (contact an Authorized Toro Distributor
for assistance).
To prevent accidentally shorting a disconnected battery cable across
other components or tools, insulate the battery cable terminal with
a 76 mm (3 inch) length of 1/2 inch internal diameter rubber hose
immediately after disconnecting the cable.
g310876
1. Battery cable terminal (typical)
Do not open the lithium-Ion batteries. There are no serviceable parts
on or in the battery pack. If you open the battery, you will void the
warranty. The battery is protected by tamper-alerting devices.
1. Park the machine on a level surface, lower the cutting units, set the key
switch to the O position and remove the key.
FF
2. Unplug the 48V battery disconnect; refer to
5–9).
3. Open the hood, and remove both side battery covers.
4. Label and disconnect the positive (+) battery cable at the center mounted
batteries, and at each set of side mounted batteries; refer to
IMPORTANT
Figure 93
2. 1/2 inch ID rubber hose
IMPORTANT
Page 5–113
48V Battery Disconnect (page
Figure
Electrical System: Batteries (Model 04590)
94.