Test The External Connection To The Lan; Replace The Wp Cables - Avaya MCC1 Hardware Manual

Test the external connection to the LAN

1 Click Start > Run to open the Run dialog box.
Type command and press
2
Type ping ipaddress, where ipaddress is a known computer on the network and press
3
to verify connectivity.
Enter
Using a terminal emulation application, type status link to test the new IP connections
4
that you have administered.

Replace the WP Cables

You must replace the WP cables, which connect the backplane to the rear connector panel, with
Twisted Pair I/O cables.
!
CAUTION:
Turn off power to the carrier or media gateway being serviced.
!
CAUTION:
When adding or replacing any hardware and associated cables and adapters, be sure to
ground yourself against electrostatic discharge (ESD) by wearing a grounded wrist strap.
For the G600 media gateway you must remove the fan assembly to access the cables.
1
Loosen the thumb screws on the fan assembly and pull it straight out as shown in
Assembly Removal'' on page
installed.
Note the orientation of the existing cables (WP-90753, LI). The WP cables may be white
2
and red or multicolored.
3 Remove the nontwisted pair WP cables from the backplane and the connector panel
slot(s).
4 In their place install the tight-twisted pair I/O cables (700181118) onto the backplane,
according to the proper orientation shown in
Cables'' on page 31. Observe the white outline printed on the backplane for the location
of each connector.
NOTE:
When viewed from the "wiring" side of the twin connectors (that is, while plugging them
into the backplane) and with the connectors oriented properly for plug-in, they should look
like ''Proper Orientation for the Twisted Pair I/O Cables'' on page
The circled pin locations are "No-Connects"; that is, they have no wires in them. At the
top there is an orange-black pair on the right and a violet-brown pair on the left.
The 50-position metal shell D connectors should be installed into the connector panel with
the longer side of the D (pins 1–25) toward the right when viewed from the rear of the
media gateway.
Adding New Hardware to Avaya™ MCC1, SCC1, and G600 Media Gateways
to open an MS-DOS command window.
Enter
30. Leave the fan assembly off until all the wires are
May 2003
Install and Administer IP Connectivity Hardware
''Proper Orientation for the Twisted Pair I/O
31.
29
''Fan