Avaya MCC1 Hardware Manual page 28

28 Adding New Hardware to Avaya™ MCC1, SCC1, and G600 Media Gateways
Install and Administer IP Connectivity Hardware
Set the Enable Eth Pt field to y.
8
9 Set the Type field to VAL.
Type the circuit pack location in the Slot field (UUCSS).
10
If a TN2501AP circuit pack is not at this location when you submit the screen, the
software prompts you to enter a VAL circuit pack location.
In the Node Name field, enter the Node Name you entered with the change node-names
11
ip command.
If you press Help, a list of administered node names appears (including the name you
administered with the change node-names ip command), and you can select from the list.
12 Set the Subnet Mask field according to your network requirements.
Gateway address is usually the same as the TN2501AP circuit pack's IP address, usually
with the fourth octet changed. Be sure to set this address according to your network
requirements.
13 Press
Type add data-module extension and press
14
The Data Module screen appears. Use this screen to administer the data module that is
associated with the TN2501AP ethernet port.
add data-module 30006
Data Extension: 30006
Network uses 1's for Broadcast Addresses? y
Set the Type field to ethernet.
15
16 Set the Port field to correspond to the circuit pack location.
The port number (final two digits) is always 33 for the TN2501AP circuit pack.
Set the Link field to an unassigned or next-available link number.
17
18 Set the Network uses 1's for Broadcast Address? field according to the
your network requirements.
19 Type a unique name in the Name field.
Press
20
Type add ip-route and press
21
22 Administer IP routes to the TN2501AP circuit pack.
Press
23
to save the changes.
Enter
DATA MODULE
Type: ethernet
Port: 1b0333
Link: 5
to save your changes.
Enter
Enter
to effect the changes.
Enter
May 2003
.
Enter
Name: VAL#2 Data Module
.
Page 1 of 1