Avaya MCC1 Hardware Manual page 26

26 Adding New Hardware to Avaya™ MCC1, SCC1, and G600 Media Gateways
Install and Administer IP Connectivity Hardware
Connect the LAN CAT5 cable to the RJ45 connector on the backplane adapter.
3
Administer the TN2501AP
After you have installed the hardware, to support an FTP session you must administer and test
the installation.
Use a terminal emulation application or Avaya Site Administration for this administration.
Type list configuration board board-location and press
1
The System Configuration report appears. Use this report to ensure that the
Communication Manager recognizes the TN2501AP circuit pack after it is latched in the
carrier slot.
list configuration board 1c08
Board
Number
01C08
Command successfully completed
2 Verify the following field values:
3 Type change node-names ip and press
The IP Node Names screen appears. Use this screen to administer the circuit pack's node
name.
Board Type
VAL-ANNOUNCEMENT
• Board Type shows VAL-ANNOUNCEMENT
Code is TN2501AP
•
SYSTEM CONFIGURATION
Code Vintage
TN2501AP HW00 FW001 01 02 03 04 05 06 07 08
.
Enter
May 2003
.
Enter
page 1
Assigned Ports
u=unassigned t=tti p=psa
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
U