Check the specified tire inflation
9
pressure.
Tire inflation pressure is specified on the
label as shown. (P. 622)
Start the engine. (P. 221)
10
To inject the sealant and inflate the
11
tire, turn the compressor switch on.
Inflate the tire until the recom-
12
mended pressure is reached.
The sealant will be injected and
1
the pressure will spike to 300
kPa (3.0 kgf/cm
or 400 kPa (4.0 kgf/cm
58 psi), and then gradually
decrease.
The air pressure gauge will dis-
2
play the actual tire inflation pres-
sure about 1 minute (15 minutes at
low temperature) after the switch
is turned on.
Inject to recommended pressure.
3
• Turn the compressor switch off
and then check the tire inflation
pressure. Being careful not to
over inflate, check and repeat the
inflation procedure until the spec-
ified tire inflation pressure is
reached.
GS350_300_GS F_OM_OM30J17E_(GE)
7-2. Steps to take in an emergency
2
or bar, 44 psi)
2
or bar,
581
7