Confirm Proper Operation - Kohler K-1360 Installation Manual

Riverjet
Flexjet - Turn the jet trim ring fully
counterclockwise and position the jet
nozzles downward.
15. Confirm Proper Operation
Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
Turn the jet trim rings fully counterclockwise. Position the jet nozzles so they face down toward the
basin.
NOTE: For Waterfall only use (no Flexjets or Riverjets), you only need to fill the whirlpool basin to a level
about 2" (50 mm) above the top of the suction covers.
NOTE: For Waterfall or Flexjets (no Riverjets), you only need to fill the whirlpool basin to a level about 2"
(50 mm) above the top of the highest Flexjet.
To operate all functions: Fill the whirlpool to a level above the water-level sensors on either side of
the Riverjets.
NOTE: The Riverjets will only operate if both water-level sensors are completely covered with water. If
the water level drops below the sensors, the Riverjets will automatically turn off, and the Flexjets will turn
on. The Riverjets and Flexjets will not operate at the same time.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.
Kohler Co.
Water-Level Sensors - To use all functions,
fill to a level above both water-level sensors.
To use only the Waterfall and Flexjets, fill
to a level 2" (51 mm) over the highest jet.
15
To use only the Waterfal, fill to a level
2" (51 mm) over the section cover.
Suction Cover
1022211-2-D