Whirlpool
Rim
Alcove Installation
Furring Strip
Planned
Wall Material
Whirlpool
Rim
Tile-In Installation
1. Prepare the Site
NOTICE: Do not support the whirlpool by the rim.
NOTICE: Provide adequate floor support.
NOTICE: Measure your actual product for site preparation. Note the model number located on the
whirlpool pump, then visit the product page at kohler.com for additional information.
Make sure the flooring offers adequate support for your whirlpool, and verify that the subfloor is
flat and level.
The whirlpool can be installed in a drop-in, flush, alcove, or tile-in installation. Construct 2x4 stud
framing designed for your particular installation. Frame the floor, or construct a frame for a raised
installation.
Use the template packed with the whirlpool to carefully lay out and cut the rough deck material.
For flush-mount installation, allow for the thickness of the planned deck material.
Position the plumbing. Cap the supplies, and check for leaks.
2. Prepare the Whirlpool
Install the drain to the whirlpool according to the drain manufacturer's instructions. Do not connect
the trap at this time.
Position a clean drop cloth or similar material in the bottom of the whirlpool. Be careful not to
scratch the surface of the whirlpool.
Kohler Co.
Whirlpool Rim
Use the roughing-in
information to
construct the stud
framing.
Whirlpool Rim
Wood Batten
5
Do not support the
whirlpool by the rim.
Drop-In Installation
Allow for the thickness of
the planned deck material.
Flush Installation
Use the
roughing-in
information to
construct the
stud framing.
1022211-2-D