Control Box Installation; Control Lever Friction Adjustment - Honda BF75D Manual

Control Box Installation

Side Mount Remote Control Box (equipped type)
This remote control box is designed to be mounted on
the starboard side. When it is mounted on the port
side, reverse the control lever installation for the port
mount type (see P. 25).
Set a spacer between the remote control box and the
boat to obtain the clearance for operation of the control
lever.
Connect the control cable to the remote control box
before installing the remote control box.
1) Select the remote control box installation position
for boat and suitable type of the remote control
box.
Recommended installation position:
– Convenient for the control lever operation
– Free from interference or restriction in routing
the cables and harnesses between the remote
control box and the outboard motor.
– Near a corner of the driver's seat.
– Underside of the remote control box is level with
the upper surface of the seat.
2) Set the remote remote control box at the
installation position and mark the drilling points for
the remote control box mounting screws.
3) Drill at the marked points using the 7 mm-diameter
drill.
4) Connect the control cables to the remote control
box (see P. 27).
5) Install the remote control box using the callars
washer, nuts and the screws.
6) Set the spacer and washers between the remote
control box and the mounting surface on the boat
as shown to obtain the clearance for smooth
operation of the control lever.
7) Install the remote control box with the control lever
set in the neutral position.
CONTROL CONTROL BOX
LEVER
6 mm SCREWS
CALLARS
SPACER
WASHERS
NUTS
28

Control Lever Friction Adjustment

Adjust the friction by turning the control lever friction
adjuster.
Side Mount Remote Control Box (Equipped type)
CONTROL LEVER
FRICTION ADJUSTER
To increase
friction
To decrease
friction