Control Cable Installation; Control Box Side - Honda BF75D Manual

CONTROL CABLE INSTALLATION

• CONTROL BOX SIDE

Side Mount Remote Control Box (equipped type):
6 mm LOCK PIN (2)
WASHER (2)
EYE END (2)
LOCK NUT (2)
1) Remove the two 5 x 25 mm tapping screws and
housing cover C.
2) Screw the lock nuts and eye ends more than 8 mm
(0.3 in) onto the thread of the control cables and
tighten the lock nuts securely to hold the pivots.
Apply marine grease to the hole of the eye end.
LOCK NUT
3) Install the shift control cable by aligning the groove
of the control cable with the cable guide plate. Then
connect the eye end to the shift arm pin using the
washer and 6 mm lock pin.
Install the washer on the lock pin side.
HOUSING COVER C
More than 8 mm (0.3 in)
EYE END
GREASE GREASE
(Marine grease)
5 x 25 mm TAPPING SCREW (2)
THROTTLE CONTROL CABLE
SHIFT CONTROL CABLE
4) Install the cable clamp spacer and throttle control
cable by aligning the groove with the cable guide
plate. Then connect the eye end to throttle arm pin
using the washer and 6 mm lock pin.
THROTTLE CONTROL CABLE
CABLE CLAMP SPACER
CABLE GUIDE
SHIFT CONTROL CABLE
5) Reinstall the housing cover C and tighten the 5 x 25
mm tapping screws.
Torque: 2 N·m (0.2 kgf·m, 1.4 lbf·ft)
27
CABLE CLAMP SPACER
THROTTLE ARM
SHIFT ARM
WASHER
EYE END
6 mm LOCK PIN