Options Installation For Universal Stations; Universal Station Complexing (Physical); Module Installation; Peripheral Installation And Cabling - Honeywell TotalPlant LCN System Installation

This section provides brief installation procedures for adding an option or feature to an existing
TotalPlant
Solution (TPS
Configuration Guide, and the information contained in the various equipment installation and
service manuals, provide the necessary information to modify or expand your system.
This section applied to TPS equipment installed before 1/01/96. The newer CE Compliant
equipment installation is covered in Appendix C.
A.1 UNIVERSAL STATION COMPLEXING (PHYSICAL)
A complete complexing kit, P-ZCKY1, is available from Honeywell for on-site expansion.
The kit includes hardware for complexing the keyboard and work-surface support trays,
for complexing the console bases, and the trim kit for the ends of each console complex.
See Section 3 for installation instructions. When viewed from the LCN, each station is
seen as a separate unit.
A.2 MODULE INSTALLATION
The LCN electronics modules are shipped complete with power cord, front cover,
attachment hardware, and LCN intercabinet cables, including tees and terminators. Refer
to installation drawings for connection details. See Section 8 for system pinning (node
addressing).
A.3 PERIPHERAL INSTALLATION AND CABLING
The standard built-in peripherals, cartridge disk drives, floppy disk drives, and trend pen
recorders, are installed and cabled into the Universal Station X at the factory. Removal and
replacement procedures are provided in the applicable service manual and installation
drawings. The matrix printer is packaged separately for shipping.
After unpacking, position the printer on the table top. Route the power cord and data
cables down the back of the console and up through the cable cutouts. Connect the power
cord into any unused receptacle on the power entry box. The data cable connections, as
applicable to the Universal Station X , are shown in Figures A-1 and A-2. See subsection
A.7 for cabling information for the Universal Work Station.
LCN System Installation
)
System. These procedures, together with the TPS System
NOTE
A-1
OPTIONS INSTALLATION FOR
UNIVERSAL STATIONS
A
Appendix A
9/96