General; Electrostatic Discharge; Clean Up; Touch-Up Colors - Honeywell TotalPlant LCN System Installation

General information about equipment care and handling.

6.1 ELECTROSTATIC DISCHARGE

Electrostatic Discharge (ESD) and its destructive affect on system electronics components
must be understood and kept under control, especially during installation and servicing of
all TPS products.
What ESD is and how it can be controlled is summarized by Technical Bulletin, TB NO.
ESD-1. How to handle system components is presented in Appendix A of the LCN
System Checkout Manual. Please follow these guidelines.

6.2 CLEAN UP

With the Equipment Cabinet(s) and Universal Station(s) physically installed and ready for a
power-up check, please take time for a general cleanup of the area. From this point on, the
habit of maintaining site cleanliness should be developed. The following steps are
recommended:
• Make a final check of all shipping containers and wrappings for small parts or smaller
containers.
• Arrange for the storage of special containers in which the peripheral devices are
shipped. These may be required if such devices are shipped to a new location or
returned for repair.
• Discard all unneeded packing materials.
• Have the room cleaned and arrange for it to be kept clean, but avoid raising dust.
Damp-mop tile floors or vacuum carpeted floors frequently.

6.3 TOUCH-UP COLORS

For all touch-up requirements, refer to the factory or to your project engineer.
LCN System Installation 6-1
6

GENERAL

Section 6
9/96