Honeywell TotalPlant LCN System Installation page 28

3.6 LCN CABLING
As shown in Figure 2-2, LCN cabinets have the intracabinet cables installed in the factory.
The system is then tested in a system configuration and the cables inside the cabinet are left
in place to be shipped with the equipment. The remaining installation task is for the
cabinets and the consoles to be cabled together as shown in Figure 3-9, Figure 3-10, and
Figure 3-11.
Coax Connection
to LCN System
Figure 3-9 — Intracabinet Coax Cabling between LCN Cabinets
After the Universal Stations have been complexed (bolted) together, coax cable can be
connected as shown in Figure 3-10 or Figure 3-11. Cables can exit and enter each US
through the bottom or through the side openings.
LCN System Installation
Rear View
Cable A
Cable B
3-12
Rear View
Cable A
Cable B
3.6
53851
9/96