BRP Evinrude E-Tec Series Installation Manual page 74

OUTBOARD RIGGING
EVINRUDE E-TEC MODELS 15–30 HP
Adjust the shif t ca ble trunnion to align with the
center of the trunnion block.
1
1. Shift linkage
2. Shift cable
Install cable retainer and screw. Tighten screw to
a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
1. Cable retainer
With remote control lever in NEUTRAL, pull firmly
on throttle cable casing to remove slack.
With engine throt tle le ver aga inst stop, place the
cable trun nion in to th e u pper anchor p ocket a nd
72
adjust the trunn ion nut so the ca sing fits onto the
throttle lever pin.
2
1
007215 1. Throttle lever pin
2. Trunnion nut
2
1. Throttle lever stop
IMPORTANT:
007121
WARD and pull back slowly to NEUTRAL. Make
sure the engine throttle lever is against the stop. If
not, remove slack by adjusting cable trunnion.
Install cable retainer and screw. Tighten screw to
a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
Install washers and ret ainer clip s o n sh ift lever
and throttle pins. Refer to
Installation on p. 51.
Move control h andle t o F OR-
Cable Retainer Clip
2
007217
1
007216