BRP Evinrude E-Tec Series Installation Manual page 64

OUTBOARD RIGGING
EVINRUDE E-TEC 60° V MODELS 115–200 HP
Route the harness under the front of the EMM and
around the port side of
with tie straps.
1
1. Harness routing
2. Tie straps
Use an I-Command Ignition and Trim Harness to
connect the outboard to the key switch and trim/tilt
control. Se al unused SystemCheck connector
with 6-Pin Connector Seal, P/N 586076.
1
1. I-Command Ignition connector
2. Trim/Tilt connector
3. SystemCheck connector (with seal)
If connecting to an existing Deutsch-style I-Com-
mand network, connect the purple wires be tween
the I-Command Ignition and Trim Harness and the
I-Command Engine Interface Cable. This connec-
tion supplies power to th e network when t he key
62
the powerh ead. Secure
005268
005266
switch is on. Newer, quick connect-style networks
do not use this connection.
1
2
1. Network power supply connector
Route the harnesses around the starboard side of
the powerhead along the same path as the battery
cables.
Secure all cables with tie-straps.
2
3
1. Anchor points
For an I-Command oil level display, an accessory
CANbus o il level sender must be installed in t he
oil t ank. Con nect the sender to th e I-Command
network. Ref er to the I-Command Digital Net-
work Guide, P/N 355008.
1
005269
1
005270